Yes | For an inoperative LH or RH door window, INSTALL a new window regulator motor. REFER to: Front Door Window Regulator Motor (501-11 Glass, Frames and Mechanisms, Removal and Installation). For an inoperative left or right rear window, INSTALL a new window regulator motor. REFER to: Rear Quarter Window Regulator Motor - Convertible (501-11 Glass, Frames and Mechanisms, Removal and Installation). |
|---|---|
No | REPAIR the circuit. |
I15 VERIFY GLOBAL OPEN FEATURE IS ENABLED IN MESSAGE CENTER
Ignition ON. Verify the global open feature (Remote Open) is enabled in the message center. REFER to the Owner's Literature.
Is the global open feature enabled in the message center?
Yes | GO to I16 |
|---|---|
No | The system is operating correctly at this time. INFORM the customer how to enable/disable the global open feature in the message center. REFER to the Owner's Literature. |
I16 CHECK THE RKE (REMOTE KEYLESS ENTRY) TRANSMITTER OPERATION
Operate the RKE lock/unlock function using all of the RKE transmitters.
Does the RKE lock/unlock function operate correctly with at least one of the RKE transmitters?
Yes | GO to I17 |
|---|---|
No | To diagnose the RKE system, REFER to: Locks, Latches and Entry Systems (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
I17 CHECK FOR CORRECT BODY CONTROL MODULE B (BCM-B) OPERATION
Ignition OFF. Disconnect and inspect all the Body Control Module B (BCM-B) connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins as necessary pushed-out pins - install new pins as necessary
Reconnect the Body Control Module B (BCM-B) connectors and all previously disconnected window system connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new Body Control Module B (BCM-B). REFER to: Body Control Module B (BCMB) (419-10 Multifunction Electronic Modules, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
The Short Drop Window Feature Does Not Operate Correctly
Refer to Wiring Diagrams Cell 100 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Glass, Frames and Mechanisms - System Operation and Component Description (501-11 Glass, Frames and Mechanisms, Description and Operation).
Possible Causes
Door window regulator motor not initialized Wiring, terminals or connectors Door ajar switch Door window regulator motor
PINPOINT TEST J : THE SHORT DROP WINDOW FEATURE DOES NOT OPERATE CORRECTLY
J1 VERIFY THE DOOR AJAR SWITCH OPERATION
Open and close the driver door and view the interior lamps operation. Open and close the passenger door and view the interior lamps operation.
Do the interior lamps operate correctly?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.