Pinpoint Test - DTC: D — 2016 workshop reference 1807

Using a diagnostic scan tool, perform RCM self-test. DIAGNOSTIC TIP: When viewing Diagnostic Trouble Codes (DTCs) with the deployable steering column disconnected, an open circuit fault is normally retrieved.

Did the on-demand DTC change from B0005:1A to B0005:13?

Yes	GO to A11
No	GO to A5

A5 CHECK FOR A SHORT BETWEEN THE DEPLOYABLE STEERING COLUMN CIRCUITS

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RCM C310A and C310B. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C2360-1		C2360-2

Is the resistance greater than 10,000 ohms?

Yes	GO to A12
No	REPAIR the circuit(s). Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A17

A6 CHECK THE DEPLOYABLE STEERING COLUMN CIRCUITS FOR AN OPEN

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect Deployable Steering Column C2360. Disconnect RCM C310A and C310B. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C310A-11		C2360-1
C310A-12		C2360-2

Are the resistances less than 0.5 ohm?

Yes	GO to A7
No	REPAIR the circuits. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A17

Source reference 1807

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.