A7 CHECK THE DRIVER SAFETY BELT RETRACTOR PRETENSIONER DEPLOYMENT CONTROL DTC (DIAGNOSTIC TROUBLE CODE) FOR A FAULT STATUS CHANGE (OPEN INDICATED)
NOTE: This pinpoint test step attempts to change the fault reported by the RCM by inducing a different fault condition. If the reported fault changes, this indicates the RCM is functioning correctly and is not the source of the fault.
Connect RCM C310A and C310B. Connect a fused jumper wire:
Click to display connectors
Lead 1 | Measurement / Action | Lead 2 |
|---|---|---|
C323-1 | C323-2 |
Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test. DIAGNOSTIC TIP: When viewing Diagnostic Trouble Codes (DTCs) with the driver safety belt retractor pretensioner circuits shorted together, a low resistance fault is normally retrieved.
Did the on-demand DTC change from B007E:13 to B007E:1A?
Yes | REMOVE the fused jumper wire and GO to A11 |
|---|---|
No | REMOVE the fused jumper wire and GO to A12 |
A8 CHECK THE DRIVER SAFETY BELT RETRACTOR PRETENSIONER DEPLOYMENT CONTROL DTC (DIAGNOSTIC TROUBLE CODE) FOR A FAULT STATUS CHANGE (SHORT TO GROUND INDICATED)
NOTE: This pinpoint test step attempts to change the fault reported by the RCM by inducing a different fault condition. If the reported fault changes, this indicates the RCM is functioning correctly and is not the source of the fault.
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect Driver Safety Belt Retractor Pretensioner C323. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test. DIAGNOSTIC TIP: When viewing Diagnostic Trouble Codes (DTCs) with the driver safety belt retractor pretensioner disconnected, an open circuit fault is normally retrieved.
Did the on-demand DTC change from B007E:11 to B007E:13?
Yes | GO to A11 |
|---|---|
No | GO to A9 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.