Pinpoint Test - DTC: W — 2016 workshop reference 1972

A5 CHECK THE LH (LEFT-HAND) FRONT IMPACT SEVERITY SENSOR AND RCM (RESTRAINTS CONTROL MODULE) CONNECTIONS (NO OPERATION INDICATED)

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Inspect the LH Front Impact Severity Sensor electrical connector C1465 to make sure it is fully seated and locked. Seat and lock the connector as necessary.

Remove the air cleaner. Refer to the appropriate section in Group 303 for the procedure.

Gain access to the RCM and inspect C310A and C310B to make sure they are fully seated and locked. Seat and lock the connector as necessary Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.

Was DTC B1413:93 retrieved on-demand during self-test?

Yes	GO to A6
No	The fault has been corrected. GO to A11

A6 CHECK THE LH (LEFT-HAND) FRONT IMPACT SEVERITY SENSOR FEED CIRCUIT FOR A SHORT TO VOLTAGE (NO OPERATION INDICATED)

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect LH Front Impact Severity Sensor C1465. Disconnect RCM C310A and C310B. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C1465-1		Ground

Is any voltage present?

Yes	REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11
No	GO to A7

A7 CHECK THE LH (LEFT-HAND) FRONT IMPACT SEVERITY SENSOR CIRCUITS FOR AN OPEN

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures).

Source reference 1972

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.