A15 CHECK FOR AN INTERMITTENT FAULT
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect LH B-pillar Side Impact Sensor C3210. Disconnect Passenger Front Door Side Impact Sensor C644. Disconnect RCM C310A and C310B. Inspect:
harness and component connectors for loose or spread terminals and loose or frayed wire connections at terminals. wire harness for any damage, pinched, cut or pierced wires. RCM C310A and C310B Connector Position Assurance (CPA) lever/lock for correct operation. repair any concerns found. Refer to Wiring Diagrams Cell 5 for schematic and connector information.
Connect LH B-pillar Side Impact Sensor C3210. Connect Passenger Front Door Side Impact Sensor C644. Connect RCM C310A and C310B. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Was DTC B1415:11, B1415:93, B1418:11, B1418:93 or B1424:11 retrieved on-demand during self-test?
Yes | The fault(s) cannot be cleared until corrected and the DTC is no longer retrieved on-demand during self-test. For DTC B1415:11, B1418:11 and, if equipped, B1424:11, GO to A2 For DTC B1415:93 AND B1418:93, GO to A6 For DTC B1415:93 ONLY , GO to A8 For DTC B1418:93 ONLY , GO to A11 |
|---|---|
No | The fault is not present and cannot be recreated at this time. Do not install any new SRS components at this time. Install SRS components only when directed to do so in the pinpoint test. GO to A16 |
A16 CHECK FOR ADDITIONAL SRS (SUPPLEMENTAL RESTRAINT SYSTEM) DIAGNOSTIC TROUBLE CODES (DTCS)
Ignition OFF. Reconnect all SRS components (if previously disconnected). If previously directed to depower the SRS, repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON.
NOTE: When selecting Restraints from the Self Test menu, Diagnostic Trouble Codes (DTCs) are retrieved from the RCM and OCSM.
Using a diagnostic scan tool, perform the Restraints self-test.
Are any RCM and/or OCSM Diagnostic Trouble Codes (DTCs) retrieved on-demand during self-test?
Yes Do not clear any Diagnostic Trouble Codes (DTCs) until all Diagnostic Trouble Codes
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.