Pinpoint Test - DTC: AG — 2016 workshop reference 2032

A2 CHECK THE RCM (RESTRAINTS CONTROL MODULE) CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)

Using a diagnostic scan tool, perform RCM self-test. Using a diagnostic scan tool, clear RCM Diagnostic Trouble Codes (DTCs). Wait 10 seconds. Using a diagnostic scan tool, perform RCM self-test.

Is DTC U0155:00 retrieved again?

Yes	GO to A3
No	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

A3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE RCM (RESTRAINTS CONTROL MODULE) SELF-TEST

Check the recorded Diagnostic Trouble Codes (DTCs) from the RCM self-test.

Is DTC U3003:16 or U3003:17 recorded?

Yes	REFER to: Pinpoint Test - DTC: AJ (501-20B Supplemental Restraint System, Diagnosis and Testing).
No	GO to A4

A4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

Using a diagnostic scan tool, perform IPC self-test. Check for recorded Diagnostic Trouble Codes (DTCs) from the IPC self-test.

Is DTC U3003:16 or U3003:17 recorded?

Yes	REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes, Diagnosis and Testing).
No	GO to A5

A5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0155:00 SET IN OTHER MODULES

Using a diagnostic scan tool, perform self-test for all modules.

Is DTC U0155:00 set in the BCM, ACM, or APIM (if equipped)?

Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (IPC). No CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new RCM.

Original table alignment retained · Scroll horizontally if needed

Source reference 2032

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.