Anti-Lock Brake System (ABS) and Stability Control
Diagnostic Trouble Code (DTC) Charts
DTC Charts
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
ABS Module DTC Chart
DTC | Description | Action |
|---|---|---|
B10DF:46 | Master Cylinder Isolation Valve: Calibration / Parameter Memory Failure | This DTC sets due to an internal failure of the ABS module or a calibration failure between the HCU and the ABS module. Using a diagnostic scan tool, CARRY OUT the Inlet Valve Calibration and then the Master Cylinder Isolation Calibration. CLEAR the DTC and REPEAT the self-test. If the DTC returns, REPEAT the 2 calibration routines making sure to FOLLOW the diagnostic scan tool directions. CLEAR the DTC and REPEAT the self-test. If the DTC returns, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
C0001:01 | TCS Control Channel "A" Valve 1: General Electrical Failure | This DTC indicates part of the ABS module has failed internally. CLEAR the DTC. REPEAT the self-test. If the DTC returns, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
C0002:01 | TCS Control Channel "A" Valve 2: General Electrical Failure | This DTC indicates part of the ABS module has failed internally. CLEAR the DTC. REPEAT the self-test. If the DTC returns, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
C0003:01 | TCS Control Channel "B" Valve 1: General Electrical Failure | This DTC indicates part of the ABS module has failed internally. CLEAR the DTC. REPEAT the self-test. If the DTC returns, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
C0004:01 | TCS Control Channel "B" Valve 2: General Electrical Failure | This DTC indicates part of the ABS module has failed internally. CLEAR the DTC. REPEAT the self-test. If the DTC returns, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.