Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C160-1 | C160-2 |
For the LH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C440-1 | C440-2 |
For the RH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C426-1 | C426-2 |
Check the maximum recorded voltage on the meter.
Is the voltage greater than 10 volts?
Yes | INSTALL a new wheel speed sensor. REFER to: Front Wheel Speed Sensor (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). REFER to: Rear Wheel Speed Sensor (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
|---|---|
No | GO to B8 |
B8 VERIFY ALL WIRING CONNECTIONS
Ignition OFF. Disconnect ABS module C135. Using a good light source, inspect ABS module C135 for the following:
corrosion - install a new connector or terminal and clean module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary spread terminals - install new terminals as necessary
Yes | GO to B9 |
|---|---|
No |
B9 CHECK FOR CORRECT ABS (ANTI-LOCK BRAKE SYSTEM) MODULE OPERATION
Connect ABS module C135. Make sure it seats and latches correctly. Connect the suspect wheel speed sensor. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.