Steering Wheel and Column Electrical Components

B1026:04

Steering Column Lock: System Internal Failure

DIAGNOSE all other Diagnostic Trouble Codes (DTCs) present. If no other Diagnostic Trouble Codes (DTCs) are present, INSTALL a new steering column lock module.

B1026:05

Steering Column Lock: System Programming Failure

CARRY OUT the BCM to Electronic Steering Column Lock (ESCL) configuration/training procedure. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B1026:09

Steering Column Lock: Component Failure

INSTALL a new steering column lock module.

B1026:49

Steering Column Lock: Internal Electronic Failure

INSTALL a new steering column lock module.

B1026:51

Steering Column Lock: Not Programmed

CARRY OUT the BCM to Electronic Steering Column Lock (ESCL) configuration/training procedure. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B1026:56

Steering Column Lock: Invalid / Incompatible Configuration

CARRY OUT the BCM to Electronic Steering Column Lock (ESCL) configuration/training procedure. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B1026:77

Steering Column Lock: Commanded Position Not Reachable

INSTALL a new steering column lock module.

B1026:87

Steering Column Lock: Missing Message

GO to Pinpoint Test D

B1026:92

Steering Column Lock: Performance or Incorrect Operation

GO to Pinpoint Test D

B1026:93

Steering Column Lock: No Operation

DIAGNOSE all other Diagnostic Trouble Codes (DTCs) present. If no other Diagnostic Trouble Codes (DTCs) are present, INSTALL a new steering column lock module.

B1026:96

Steering Column Lock: Component Internal Failure

INSTALL a new steering column lock module.

B108A:01

Start Button: General Electrical Failure

GO to Pinpoint Test A

B108A:24

Start Button: Signal Stuck High

GO to Pinpoint Test A

B1142:29

Ignition Status 1: Signal Invalid

GO to Pinpoint Test A

B1184:11

Steering Column Lock Output: Circuit Short To Ground

GO to Pinpoint Test D

B1184:15

Steering Column Lock Output: Circuit Short To Battery or Open

GO to Pinpoint Test D

B1240:11

Start Button Mode Indicator: Circuit Short to Ground

GO to Pinpoint Test B

B1240:15

Start Button Mode Indicator: Circuit Short to Battery or Open

If the ignition mode indicator is inoperative, GO to Pinpoint Test B If the ignition mode indicator is always on, GO to Pinpoint Test C

B130F:12

Run Accessory Control: Circuit Short to Battery

REFER to: Wipers and Washers (501-16 Wipers and Washers, Diagnosis and Testing).

B130F:14

Run Accessory Control: Circuit Short to Ground or Open

REFER to: Wipers and Washers (501-16 Wipers and Washers, Diagnosis and Testing).

All other Diagnostic Trouble Codes (DTCs)

-

REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).