No | GO to G5 |
|---|
G5 RECHECK THE PAM (PARKING ASSIST CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Operate the system and test for normal operation. Check the PAM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U0121:00 still present?
Yes | GO to G6 |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
G6 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0121 SET IN OTHER MODULES
Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs). Ignition OFF. Ignition ON. Wait 10 seconds. Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC U0121 set in any other module?
Yes | GO to G7 |
|---|---|
No | GO to G8 |
G7 CHECK FOR CORRECT ABS (ANTI-LOCK BRAKE SYSTEM) MODULE OPERATION
Ignition OFF. Disconnect and inspect all ABS module connectors and related in - line connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the ABS module connectors and related in - line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
G8 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.