Module Network Input Messages - FCIM — 2016 workshop reference 4300

Message	Module
Accelerator pedal position	PCM	Used to determine the throttle position status for the ANC and ESE system operation.
Driver's door ajar status	BCM	Used to enable the ANC and ESE system if the driver’s door (and all other doors and luggage compartment lid) is closed, or to disable the ANC and ESE system if the driver's door is ajar.
Engine RPM data	PCM	Used to determine the engine rotation speed for the ANC and ESE system operation.
Engine status	PCM	Used to enable the ANC and ESE system if the engine is ON, or to disable the ANC and ESE system if the engine is OFF.
Engine torque	PCM	Used for ANC and ESE system operation by indicating the amount of engine torque being produced (in Nm).
Ignition status	GWM	Used to indicate the ignition state (OFF, ACCESSORY, CRANK, RUN, and START) required for DACMC operating modes and fault reporting.
Luggage compartment lid ajar status	BCM	Used to enable the ANC and ESE system if the luggage compartment lid (and all other doors) is closed, or to disable the ANC and ESE system if the luggage compartment lid is ajar.
Passenger door ajar status	BCM	Used to enable the ANC and ESE system if the front passenger door (and all other doors and luggage compartment lid) is closed, or to disable the ANC and ESE system if the front passenger door is ajar.
Power up chime modules	IPC	Used to initiate the audio system as the chime source.

Module Network Input Messages - FCIM

Broadcast Message	Originating Module	Message Purpose
Audio source selection	ACM	Used to indicate the selected audio system source.
Day/night status	BCM	Used for day/night illumination status for the FCIM.
Ignition status	BCM	Used to indicate the ignition state (OFF, ACCESSORY, RUN, and START) required for FCIM operating modes and fault reporting.
Power mode	IPC	Used to disable the functionality of the FCIM due to the load shedding feature.
Vehicle configuration data	BCM	Used to verify vehicle configuration data such as the VIN and system module configuration.

Module Network Input Messages - IPC

Broadcast Message	Originating Module	Message Purpose
Audio source selection	ACM	Used to display the selected audio source on the IPC.
Display language request	APIM	Used to display information on the IPC in the selected language.
DSP chime status	Audio DSP module	Used to indicate the status of the warning chimes being played through the audio system.

Source reference 4300

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.