D26 CHECK THE SATELLITE RADIO/GPS (GLOBAL POSITIONING SYSTEM) ANTENNA UNIT SHIELD FOR CONTINUITY TO ANTENNA UNIT BASE
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
Satellite radio/GPS antenna coaxial cable shield at the antenna unit (component side) | Satellite radio/GPS antenna base (unpainted surface) |
Is the resistance less than 1 ohm?
Yes | INSPECT and REPAIR any corrosion on the antenna unit base and/or vehicle mounting surface. REINSTALL the antenna and ensure the proper torque value is achieved. REFER to: Satellite Radio Antenna (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). |
|---|---|
No | INSTALL a new satellite radio/GPS antenna. REFER to: Satellite Radio Antenna (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation). |
D27 CHECK THE SDL (SIRIUS DATA LINK) CIRCUITS FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect: ACM C240B. Disconnect: APIM C2383. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C240B-6 | Ground | |
C240B-19 | Ground |
Is any voltage present?
Yes | REPAIR the circuit in question. |
|---|---|
No | GO to D28 |
D28 CHECK THE SDL (SIRIUS DATA LINK) CIRCUITS FOR A SHORT TO GROUND
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.