Description | Fault Trigger Conditions | DTC Type |
|---|---|---|
B1A08:13 Speaker #8: Circuit Open | Set by the audio DSP module when an open is detected on the center instrument panel speaker circuits. | On-demand |
DTC
Possible Sources
Speakers Wiring, terminals, or connectors Audio DSP module
PINPOINT TEST M : THE CENTER INSTRUMENT PANEL SPEAKER IS INOPERATIVE
M1 CHECK THE AUDIO SIGNAL TO THE CENTER INSTRUMENT PANEL SPEAKER
Ignition OFF. Disconnect: Center Instrument Panel Speaker C2359. Operate the audio system in AM/ FM mode. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2359-1 | C2359-2 |
Is a fluctuating AC voltage present?
Yes | INSTALL a new center instrument panel speaker. REFER to: Instrument Panel Speaker (415-00B) . |
|---|---|
No | GO to M2 |
M2 CHECK THE AUDIO CIRCUITS TO THE CENTER INSTRUMENT PANEL SPEAKER FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect: Audio DSP Module C2385C. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2359-1 | Ground | |
C2359-2 | Ground |
Is any voltage present?
Yes | REPAIR the circuit in question. |
|---|---|
No | GO to M3 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.