Is the concern still present?

Pushed-out pins (install new pins as necessary)

Reconnect the audio DSP module connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Yes		CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, discontinue this test and follow TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new audio DSP module. REFER to: Audio Digital Signal Processing (DSP) Module (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).
No		The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

The Right Parcel Shelf Speaker Is Inoperative (Coupe)

Refer to Wiring Diagrams Cell 131 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Information and Entertainment System (415-00B) . See Audio DSP Module.

DTC Fault Trigger Conditions

DTC Description Fault Trigger Conditions DTC Type B13F7:13 Audio Input 1: Set by the audio DSP module when an open is detected on the Continuous Circuit Open RH audio signal circuits from the ACM to the audio DSP module. B1A06:01 Speaker #6: Set by the audio DSP module when a failure is detected on the On-demand General Electrical RHR quarter panel (convertible) or right parcel shelf (coupe) Failure speaker circuits. B1A06:11 Speaker #6: Set by the audio DSP module when a short to ground is Continuous and Circuit Short To detected on the RHR quarter panel (convertible) or right parcel on-demand Ground shelf (coupe) speaker circuits. When DTC B1A06:11 is set, the speaker output is disabled. B1A06:12 Speaker #6: Set by the audio DSP module when a short to voltage is Continuous and Circuit Short To detected on the RHR quarter panel (convertible) or right parcel on-demand Battery shelf (coupe) speaker circuits. When DTCB1A06:12 is set, the speaker output is disabled. B1A06:13 Speaker #6: Set by the audio DSP module when an open is detected on the On-demand Circuit Open RHR quarter panel (convertible) or right parcel shelf (coupe) speaker circuits.

Original table alignment retained · Scroll horizontally if needed

Possible Sources

Speaker Wiring, terminals, or connectors ACM

Source reference 4429

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.