MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Information and Entertainment Systems

All APIM Mono Outputs Are Inoperative Or Do Not Operate Correctly

415-00B General Information -Vehicles With Touchscreen Display

2016 MustangReference 4,450 / 6,619HTML edition
← Chapter contents

Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).

No

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

All APIM Mono Outputs Are Inoperative Or Do Not Operate Correctly

Refer to Wiring Diagrams Cell 131 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Information and Entertainment System - System Operation and Component Description (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Description and Operation). See SYNC® System, ACM, and APIM.

Possible Sources

Wiring, terminals, or connectors APIM Audio DSP Module

PINPOINT TEST V : ALL APIM (SYNC MODULE) MONO OUTPUTS ARE INOPERATIVE OR DO NOT

OPERATE CORRECTLY

V1 CHECK FOR AN AC (ALTERNATING CURRENT) VOLTAGE SIGNAL ON THE APIM (SYNC MODULE) MONO OUTPUT CIRCUITS TO THE AUDIO DSP (AUDIO DIGITAL SIGNAL PROCESSING MODULE) MODULE

NOTICE: This pinpoint test step directs testing circuits using a back-probe method. Use the special back-probe tool POM6411. Do not force test leads or other probes into connectors. Adequate care must be exercised to avoid connector terminal damage, while ensuring that good electrical contact is made with the circuit or terminal. Failure to follow these instructions may cause damage to wiring, terminals, or connectors, and may cause subsequent electrical faults.

Access Bezel Diagnostics. REFER to: Bezel Diagnostics (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, General Procedures). While back-probing Audio DSP module C4452A, measure the AC voltage while performing the Tones Test.

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

C4452A-10

C4452A-20

415-00B General Information -Vehicles With Touchscreen Display — original illustration 1, reference 4450Original colors & callouts · Select to enlarge

Is the AC voltage momentarily between 2.8-4.6 volts when the Mono Alert 1 and Mono Alert 2 are being tested?

Yes

GO to V7

No

GO to V2

Source reference 4450

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.