MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

P0690 - Electronic Control Module (ECM)/Powertrain Control Module (PCM) Power Relay Sense Circuit

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,878 / 6,619HTML edition
← Chapter contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

Powertrain DTC Charts and Descriptions 4-91

Diagnostic Trouble Code (DTC) Charts and Descriptions

P0690 - Electronic Control Module (ECM)/Powertrain Control Module (PCM) Power Relay Sense Circuit High (Continued)

• Damaged fuel pump relay

• Damaged PCM power relay

Diagnostic Aids:

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test B.

P06A6 - Sensor Reference Voltage A Circuit Range/Performance

Description: This DTC sets when the VREF circuit is not within a calibrated voltage range.

Possible Causes: • VREF circuit short to voltage

• VREF circuit short to ground

• Damaged sensor

Diagnostic Aids: This DTC may set with additional component DTCs.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test C.

P06A7 - Sensor Reference Voltage B Circuit Range/Performance

Description: This DTC sets when the VREF circuit is not within a calibrated voltage range.

Possible Causes: • VREF circuit short to voltage

• VREF circuit short to ground

• Damaged sensor

Diagnostic Aids: This DTC may set with additional component DTCs.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test C.

P06A8 - Sensor Reference Voltage C Circuit Range/Performance

Description: This DTC sets when the VREF circuit is not within a calibrated voltage range.

Possible Causes: • VREF circuit short to voltage

• VREF circuit short to ground

• Damaged sensor

Diagnostic Aids: This DTC may set with additional component DTCs.

Application Key On Engine Off Key On Engine Running Continuous Memory

All GO to Pinpoint Test C.

P06B6 - Internal Control Module Knock Sensor Processor 1 Performance

Description: This DTC sets when the PCM has detected an error condition with the knock sensor (KS) processor integrated

circuit.

Possible Causes: • Damaged PCM

Diagnostic Aids: Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Check for

aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to Section 2, Flash Electrically Erasable Programmable Read Only Memory (EEPROM).

Application Key On Engine Off Key On Engine Running Continuous Memory

All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.

2016 Powertrain Control/Emissions Diagnosis, Gasoline Engines, 3/2015

Source reference 4878

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.