MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

A: No Start A: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,937 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

A7 CHECK FOR SPARK AT THE CYLINDERS

• Ignition OFF.

• Remove the fuel pump fuse to disable the fuel pump.

• Disconnect the ignition coils from the spark plugs on half of the number of cylinders on the engine.

• Connect the Adjustable Ignition Spark Tester THX458 or equivalent to a spark plug boot and repeat for half the number of cylinders on the engine.

• Observe the spark tester while cranking the engine.

Is a bluish-white spark present for each tested cylinder?

Yes

No

GO to A8 .

For EcoSport 1.6L,

Fiesta 1.6L TiVCT, and

KA 1.5L, GO to Pinpoint Test JE .

For all others, GO to Pinpoint Test JF .

A8 CHECK THE FUEL PRESSURE

WARNING: THE FUEL SYSTEM REMAINS PRESSURIZED WHEN THE ENGINE IS NOT RUNNING. TO PREVENT INJURY OR FIRE, USE CAUTION WHEN WORKING ON THE FUEL SYSTEM.

REFER TO THE FUEL SYSTEM WARNING INFORMATION AT THE BEGINNING OF PINPOINT TEST HC.

FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.

Note: While activating the fuel pump on an electronic returnless fuel system a brief pressure spike may occur.

• Ignition OFF.

• Relieve the fuel pressure. Refer to the Workshop Manual Section 310-00, Fuel System for the Fuel System Pressure Release procedure.

• Connect the fuel pressure gauge using the appropriate fuel pressure test hose and adaptor.

• Ignition ON, engine OFF.

• Access the PCM and control the FP (MODE) PID.

• Activate the fuel pump to obtain maximum fuel pressure.

Is the fuel pressure within specification (refer to the fuel pressure chart in Pinpoint Test HC)?

Yes

No

GO to A9 .

GO to Pinpoint Test HC .

A9 CHECK THE FUEL PRESSURE LEAKDOWN

• Ignition ON, engine OFF.

• Access the PCM and control the FP (MODE) PID.

• Activate the fuel pump to obtain maximum fuel pressure.

• Monitor the FRP.

• Verify the fuel pressure remains within 34 kPa (5 psi) of the maximum pressure for 1 minute after turning the pump off.

Source reference 4937

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.