Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.
Original table alignment retained · Scroll horizontally if needed
Is the voltage between 4.5 - 5.5 V?
Yes | No |
|---|---|
GO to C22 . | INSTALL a new CMP sensor. REFER to the Workshop Manual Section 303-14, Electronic Engine Controls. Clear the PCM DTCs. REPEAT the self-test. |
C22 CHECK THE REFERENCE VOLTAGE WITH THE WASTEGATE VACUUM SENSOR CONNECTED
Note: If the vehicle is not equipped with a wastegate vacuum sensor or if this sensor was used for the VREF measurement in C3, GO to C23 .
Note: Only measure the circuits that apply to the vehicle being diagnosed.
• Ignition OFF.
• Wastegate Vacuum Sensor connector connected.
• Ignition ON, engine OFF.
• Measure the voltage between:
( + ) Suspect Sensor Connector, Harness Side | ( - ) |
|---|---|
VREF | Ground |
Is the voltage between 4.5 - 5.5 V?
Yes | No |
|---|---|
GO to C23 . | INSTALL a new Wastegate Vacuum Sensor. REFER to the Workshop Manual Section 303- 14, Electronic Engine Controls. Clear the PCM DTCs. REPEAT the self-test. |
C23 CHECK THE REFERENCE VOLTAGE WITH THE MAPT SENSOR CONNECTED
Note: If the vehicle is not equipped with a MAPT sensor or if this sensor was used for the VREF measurement in C3, GO to C24 .
Note: Only measure the circuits that apply to the vehicle being diagnosed.
• Ignition OFF.
• MAPT Sensor connector connected.
• Ignition ON, engine OFF.
• Measure the voltage between:
( + ) Suspect Sensor Connector, Harness Side | ( - ) |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.