MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

DA: Intake Air Temperature (IAT) Sensor DA: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 4,979 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

Is any voltage present?

Yes

No

REPAIR the short circuit. Clear the PCM DTCs. REPEAT the self-test.

GO to DA5 .

DA5 INTERMITTENT CHECK

• Ignition OFF.

• PCM connector connected.

• For EcoSport, F-150 3.5L TIVCT, F-150 5.0L, Fiesta 1.6L TIVCT, Flex 3.5L TIVCT, KA, MKS

3.7L, MKT 3.7L, Mustang 3.7L, Taurus 3.5L TIVCT, Taurus 3.7L and Transit 3.7L,

• MAPT Sensor connector connected.

• For all others,

• IAT Sensor connector connected.

• Ignition ON, engine OFF.

• Access the PCM and monitor the IAT (VOLT) PID.

• While observing the PID, wiggle, shake, and bend small sections of the wiring harness working from the sensor to the PCM.

• Lightly tap on the sensor and wiggle the harness connector to simulate road shock.

Does the IAT PID reading change?

Yes

No

REPAIR as necessary.

For EcoSport, F-150 3.5L TIVCT, F-150 5.0L, Fiesta 1.6L TIVCT, Flex 3.5L TIVCT, KA, MKS

3.7L, MKT 3.7L, Mustang 3.7L, Taurus 3.5L TIVCT, Taurus 3.7L and Transit 3.7L, INSTALL a new MAPT sensor.

For all others, INSTALL a new IAT sensor. REFER to the Workshop Manual Section 303- 14, Electronic Engine Controls. RESET the keep alive memory (KAM). REFER to Section 2, Resetting The Keep Alive Memory (KAM).

REPEAT the self-test.

GO to DA6 .

DA6 CHECK THE IAT CIRCUIT VOLTAGE CYCLING INTEGRITY

• Ignition OFF.

• For EcoSport, F-150 3.5L TIVCT, F-150 5.0L, Fiesta 1.6L TIVCT, Flex 3.5L TIVCT, KA, MKS

3.7L, MKT 3.7L, Mustang 3.7L, Taurus 3.5L TIVCT, Taurus 3.7L and Transit 3.7L,

• MAPT Sensor connector disconnected.

• Ignition ON, engine OFF.

• Access the PCM and monitor the IAT (VOLT) PID.

• Record the IAT PID value.

• Connect a 5 amp fused jumper wire between the following:

Point A MAPT Sensor Connector, Harness Side

Point B

IAT

Ground

Source reference 4979

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.