MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

DW: Heated Oxygen Sensor (HO2S) DW: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,077 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

• PCM connector disconnected.

• For HO2S11,

• Measure the resistance between:

( + ) HO2S11 Connector, Harness Side

( - ) PCM Connector, Harness Side

HTR11

HTR11

• For HO2S12,

• Measure the resistance between:

( + ) HO2S12 Connector, Harness Side

( - ) PCM Connector, Harness Side

HTR12

HTR12

• For HO2S22,

• Measure the resistance between:

( + ) HO2S22 Connector, Harness Side

( - ) PCM Connector, Harness Side

HTR22

HTR22

Is the resistance less than 5 ohms?

Yes

No

GO to DW15 .

REPAIR the open circuit. Clear the PCM DTCs. REPEAT the self-test.

DW15 CHECK THE HO2S HEATER FOR SHORT CIRCUITS

• For HO2S11,

• Measure the resistance between:

( + ) HO2S11 Connector, Harness Side

( - )

HTR11

Ground

• Measure the resistance between:

( + ) HO2S11 Connector, Harness Side

( - ) HO2S11 Connector, Harness Side

HTR11

VPWR

HTR11

SIGRTN

HTR11

HO2S11

• For HO2S12,

• Measure the resistance between:

( + ) HO2S12 Connector, Harness Side

( - )

HTR12

Ground

Source reference 5077

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.