MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

HD: Misfire Detection Monitor HD: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,149 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

For Escape/Kuga 2.5L,

Fusion 2.5L, and

Transit Connect 2.5L, GO to HD12 .

For all others, GO to HD14 .

REPAIR the vacuum system.

Clear the PCM DTCs. REPEAT the self-test.

HD12 MONITOR THE EEGR SYSTEM RELATED PIDS

• Ignition ON, engine running.

• Bring the engine to normal operating temperature.

• Access the PCM and monitor the EGRMC1F (MODE), EGRMC2F (MODE), EGRMC3F (MODE) and EGRMC4F (MODE) PIDs.

• Access the PCM and monitor the MAP (PRESS) PID.

• Record the PID values with the engine idling.

• Ignition ON, engine OFF.

• Record the PID values with the engine off.

• Compare the recorded PID values to the typical reference values in Section 6 , Reference Values.

Are any values out of range?

Yes

No

GO to Pinpoint Test KD and DIAGNOSE the EGR system.

GO to HD13 .

HD13 RECREATE THE MISFIRE SYMPTOM WITH EEGR SYSTEM DISABLED

Note: The PCM may store EGR system related DTCs during this procedure.

Note: To recreate the original conditions that set the DTC or caused the symptom, the vehicle may require driving.

• Ignition OFF.

• EEGR Assembly connector disconnected.

• Access the misfire freeze frame data (if available) and record the operating conditions.

• Obtain information from the customer information worksheet or any other available data from the customer.

• Recreate the misfire symptom using the freeze frame and customer information.

Can the symptom be recreated?

Yes

No

GO to HD14 .

REMOVE and INSPECT the EEGR for signs of contamination, unusual wear, carbon deposits, binding or other damage. REFER to the Workshop Manual Section 303-08, Engine Emission Control for more EGR system information. REPAIR as necessary.

Clear the PCM DTCs. REPEAT the self-test.

Source reference 5149

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.