Headlamps

DTC

B1D03:11

Right High Beam Circuit: Circuit Short to Ground

GO to Pinpoint Test C

B1D03:15

Right High Beam Circuit: Short to Battery or Open

If the high beam is inoperative, GO to Pinpoint Test C If the high beam is always on, GO to Pinpoint Test F

U1000:00

Solid State Driver Protection Active -Driver Disabled: No Sub Type Information

The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.

U3000:49

Control Module: Internal Electronic Failure

The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is

corrected, Click here to access Guided Routine (BCM).

All other BCM Diagnostic Trouble Codes (DTCs)

-

REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).

DTC

B1007:09

High-Beam Headlamp Switch: Component Failure

INSTALL a new LH steering column multifunction switch. REFER to: Steering Column Multifunction Switch LH (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). TEST the system for normal operation.

If the concern still exists, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).

B1D36:09

Turn Indicator Switch: Component Failure

INSTALL a new LH steering column multifunction switch. REFER to: Steering Column Multifunction Switch LH (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). TEST the system for normal operation.

If the concern still exists, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).

All other SCCM Diagnostic Trouble Codes (DTCs)

-

REFER to: Steering Wheel and Column Electrical Components (211-05 Steering Wheel and Column Electrical Components, Diagnosis and Testing).