RH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1041-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to A6 |
|---|---|
No | REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). |
A6 CHECK THE LOW BEAM POWER SUPPLY CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
LH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1021-1 | C2280G-4 |
Click to display connectors
RH Headlamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1041-1 | C2280G-2 |
Is the resistance less than 3 ohms?
Yes | GO to A9 |
|---|---|
No | REPAIR the circuit in question. |
A7 CHECK THE HEADLAMP GROUND CIRCUITS FOR AN OPEN
Measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.