Yes | GO to H5 |
|---|---|
No | REPAIR the circuit. |
H5 CHECK THE HEADLAMP LEVELING CIRCUIT TO THE HEADLAMP LEVELING MOTOR FOR AN OPEN
Disconnect: Headlamp switch C205 (if not previously disconnected). Disconnect: LH Headlamp Control Module C1024 and RH Headlamp Control Module C1044 (both inoperative). Disconnect: LH Headlamp Control Module C1024 (LH only inoperative). Disconnect: RH Headlamp Control Module C1044 (RH only inoperative). Measure:
Click to display connectors
Both or LH only inoperative
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1024-2 | C205-1 |
Click to display connectors
RH only inoperative
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1044-2 | C205-1 |
Is the resistance less than 3 ohms?
Yes | If the only the LH or RH is inoperative, INSTALL a new headlamp assembly. REFER to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation). If both are inoperative, GO to H6 |
|---|---|
No | REPAIR the circuit. |
H6 CHECK THE HEADLAMP LEVELING CIRCUIT TO THE HEADLAMP LEVELING MOTOR FOR A SHORT TO VOLTAGE
Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C205-1 | Ground |
Is any voltage present?
Yes | REPAIR the circuit. |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.