RH Rear Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C499-5 | Ground |
Is the voltage greater than 11 volts?
Yes | INSTALL a new rear lamp assembly. REFER to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | GO to B16 |
B15 CHECK THE REAR LAMP ASSEMBLY GROUND CIRCUIT
While applying the brake pedal, measure:
Click to display connectors
LH Rear Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C498-5 | C498-6 |
Click to display connectors
RH Rear Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C499-5 | C499-6 |
Is the voltage greater than 11 volts?
Yes | INSTALL a new rear lamp assembly. REFER to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation). |
|---|---|
No | REPAIR the circuit. |
B16 CHECK FOR CORRECT BCMB (BODY CONTROL MODULE B) OPERATION
Disconnect and inspect all BCMB connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the BCMB connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.