Passive Anti-Theft System (PATS)

DTC

B10C7:01

Interior Trunk Antenna: General Electrical Failure

GO to Pinpoint Test A

B10C9:01

Interior Front Antenna: General Electrical Failure

GO to Pinpoint Test A

B10D7:05

PATS Key: System Programming Failure

DIAGNOSE all other Diagnostic Trouble codes (DTCs) first. If no other Diagnostic Trouble codes (DTCs) are present, PROGRAM the suspect passive key again. If key programming fails, REPLACE the suspect passive key. PROGRAM the new passive key. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B10D7:55

PATS Key: Not Configured

The Configurable Engine Immobilizer (CEI) was not completed during the PMI procedure. CARRY OUT the Configurable Engine Immobilizer (CEI) as part of the PMI procedure.

B10D8:00

PATS Key Less Than Minimum Programmed: No Sub Type Information

Less than 2 keys are programmed (minimum of 2 keys must be programmed). PROGRAM the customer's second key. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B10DA:51

PATS Target Identifier: Not Programmed

There is no PCM ID stored in the BCM memory. PERFORM a parameter reset. REFER to: Anti-Theft Security Access (419-01B Passive Anti-Theft System (PATS), General Procedures).

B11C6:01

Passenger Door External Antenna: General Electrical Failure

GO to Pinpoint Test A

B11CA:01

Driver Door External Antenna: General Electrical Failure

GO to Pinpoint Test A

All other Diagnostic Trouble Codes (DTCs)

-

REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).