Searchable diagram text · automated transcription
Recognition can misread symbols, connector labels, and numbers. Read the original illustration for those details.
Introduction Component testing procedures are provided to determine whether a component is good or bad. Testing information for each component includes a schematic, a view of the terminal locations and step-by-step test procedures. Terminal locations are identified by numbers or letters that may be on the component or next to it. Terminals The compenent connector MUST BE REMOWED before testing. To test a single circuit within the component, select that circuit under the column "Circuit to test". If you wish to lest the complete component, perform all tests. Connect the tester to the terminals shown in the second column and operate the companent as shown in the third column.
Source reference 6546
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.