E7 CHECK THE HEATER CIRCUIT FOR A SHORT TO GROUND AT THE EXTERIOR MIRROR
Click to display connectors
LH Exterior Mirror
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-6 | Ground |
Click to display connectors
RH Exterior Mirror
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-6 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to E8 |
|---|---|
No | REPAIR the circuit. |
E8 CHECK THE DOOR MODULE DIAGNOSTIC TROUBLE CODES (DTCS) WITH THE EXTERIOR MIRROR DISCONNECTED
Connect: DDM C501B or PDM C652B. Ignition ON. Using a diagnostic scan tool, clear the DDM or PDM Diagnostic Trouble Codes (DTCs).
Is DDM DTC B1163:15 or PDM DTC B1164:15 present?
Yes | GO to E11 |
|---|---|
No | For the LH exterior mirror, GO to E10 For the RH exterior mirror, GO to E9 |
E9 CHECK FOR CORRECT PDM (PASSENGER DOOR MODULE) OPERATION
Disconnect and inspect all PDM connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the PDM connectors and all previously disconnected exterior mirror system connectors. Make sure they seat and latch correctly. Operate the system to determine if the concern is still present.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.