Air is drawn into the deactivated cylinders. This helps to control the temperature of the engine internal components. The deactivated cylinders are alternated to allow even cooling of all the cylinders.
NOTE: If the driver is using a high percentage of throttle travel (for example, an overtaking maneuver) when the PCM starts engine deactivation (Stage 2), the deactivation will be delayed for 10 seconds.
NOTE: After 2-cylinder operation has begun, the engine will not revert to 4-cylinder operation, even if the temperature should fall, until the ignition is switched off and then on again.
NOTE: The MIL can only be extinguished by using a scan tool after the fault has been rectified and the DTC cleared.
Stage 3 of the strategy will commence if the engine temperature continues to rise. This results in the engine being totally disabled before major engine damage or seizure occurs. The Powertrain Check Lamp will begin to flash, indicating to the driver that the engine will be switched off after 30 seconds. This allows the driver time to choose a suitable parking place.
Open Loop Mode
This mode is entered when the ECT sensor indicates a high engine temperature that is rising at a dangerously high rate, much faster than expected based on current engine running conditions. This mode can also be entered when all sensors used in Fail Safe Cooling determination are failed.
When this mode is activated, the PCM will restrict load, and restrict engine speed to below 3000 RPM, then start ramping engine speed down slowly to as low as 800 RPM and hold the speed there.
At the same time, the PCM will also move the temperature gauge pointer into the red zone and the
P1285 code is set.
If the engine is not switched off after a short period of time, the engine will be totally disabled before major engine damage or seizure occurs, The Powertrain Check Lamp will begin the flash, indicating to the driver that the engine will be switched off. The P1299 Code is set.
If the driver decides to restart the vehicle, it will be restarted but with the P1299 still set the engine speed is limited to 800 RPM. This mode can only be reset by clearing the DTC using a diagnostic scan tool.
DIAGNOSIS AND TESTING > ENGINE COOLING
Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.