Starting System — Pinpoint Test(S) — Pinpoint Test A : Engine Does Not Crank — Starting System - 3.7L Duratec (227kW & 301PS) · Reference 6275

Refer to Starting System for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Starting System - System Operation and Component Description .

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
P06E9	Engine Starter Performance	The PCM sets this DTC when no engine rotation is detected during a crank event.
P0830:11	Clutch Pedal Switch "A" Circuit: Circuit Short To Ground	The BCM sets this DTC when a short to ground is detected on the clutch bottom of travel circuit during an on-demand self test.

Possible Sources

Battery

Battery cables

IPC

Starter motor

BJB starter relay

Visual Inspection and Diagnostic Pre-checks

Inspect the run/start relay.

Inspect the high current BJB connections.

Verify the BJB fuse 60 (5A).

Verify the BJB fuse 30 (30A).

Inspect the passive key.

Inspect the CPP switch (manual transmission only).

DIAGNOSIS AND TESTING > STARTING SYSTEM > PINPOINT TEST(S) > PINPOINT

TEST A : ENGINE DOES NOT CRANK > PINPOINT TEST A : ENGINE DOES NOT CRANK

A1 PERFORM INSPECTION AND VERIFICATION

NOTE: Make sure battery voltage is greater than 12.2 volts prior to and during this pinpoint test.

Ford_Mustang_all_2015-2017.pdf · source reference 6275

Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.