MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2015–2017 source collection · Additional coverage

TPMS Reminder Reset - Procedure 1

Maintenance Reminder Light (Reset Procedures)

General Ford referenceSource reference 7,852HTML edition
← Chapter contentsManual collection

Check the named application. This is a general Ford appendix and may describe vehicles other than Mustang. Model and year tables take precedence over the collection filename. Any emissions standards are historical source material.

stationary for more than 30 minutes, a TPM sensor Activation procedure may be needed. Make sure the warning light goes off. If the warning light stays on, there is a malfunction in the TPM system. See appropriate manufacturer service information.

NOTE: When the tire pressure warning light flashes for 70 seconds and then remains illuminated, after bulb-check has been performed and message center displays warning messages, there is a malfunction in the TPM system. See appropriate manufacturer service information.

NOTE: Under the following conditions, the TPM system may not function properly:

Low tire pressure.

Tire pressure sensor is missing or damaged.

Spare tire is installed as a road wheel.

Incorrect tire pressure sensor is installed.

Tire pressure sensor installed incorrectly.

Non-OEM wheels installed (aftermarket rims).

Non-OEM equipped run-flat tires installed.

Other non-OEM modifications (roll cages, service barriers, part racks, ladder racks, etc.)

NOTE: The tire pressure sensor training procedure must be done on a single vehicle, in an area without Radio Frequency (RF) noise and at least 3 ft. (1 m) away from any other vehicle equipped with TPM system. RF noise is generated by electrical motor and appliance operation, cellular telephones and remote transmitters, power inverters and portable entertainment equipment.

NOTE: A new tire pressure sensor is shipped in an OFF mode (or battery saver mode), and must be turned ON before it can be trained. To turn the sensor on, inflate the tire to the recommended inflation pressure and wait at least 2 minutes, then continue with the sensor training procedure.

1. Turn ignition switch to OFF position, then press and release brake pedal.

2. Turn ignition switch from OFF position to the RUN position 3 times, ending in RUN position. Do not wait more than one minute between each key cycle.

3. Press and release the brake pedal.

4. Turn ignition switch to OFF position.

Ford_Mustang_all_2015-2017.pdf · source reference 7852

Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.