Check the named application. This is a general Ford appendix and may describe vehicles other than Mustang. Model and year tables take precedence over the collection filename. Any emissions standards are historical source material.
PROCEDURE 5 > VEHICLES WITHOUT MESSAGE CENTER
1. To reset the system, turn ignition switch to ON position.
2. Press and hold the Trip/Odometer reset button, and wait until "TIRE RESET" or "CHECK TIRE AND RESET" is displayed in odometer display window.
3. Continue to press the button for 3 seconds, then release. After 3 seconds, the low tire pressure warning light will flash 3 times, indicating that the low tire warning system reset procedure is complete.
TIRE PRESSURE MONITOR SYSTEM REMINDER > TPMS REMINDER RESET -
PROCEDURE 6
1. Drive the vehicle above 20 mph (32 km/h) for at least two minutes and then park in a location where you can easily get to all four tires and have access to an air pump.
2. Turn the ignition ON, with the engine OFF.
3. Turn the hazard flashers on then off three times. This must be accomplished within 10 seconds. If the reset mode has been entered successfully, the horn will sound once, the system indicator will flash and the message center (if equipped) will display TRAIN LEFT FRONT TIRE. If this does not occur, please try again starting at Step 2.
4. Place a transmitter activation tool on the left front tire wall at the valve stem. Press the activation button. The horn will sound briefly to indicate that the tire pressure sensor has been recognized.
5. Within 2 minutes after the horn sounds, place activation tool on the right front tire wall at the valve stem. Then press the activation button to train the right front tire pressure sensor. Repeat procedure for right rear and left rear tires.
6. After all four tires have been trained, remove the valve cap from the valve stem on the left front tire; decrease the air pressure until the horn sounds. The single horn chirp confirms that the sensor identification code has been learned by the module for this position. If a double horn is heard, the reset procedure was unsuccessful, and must be repeated.
7. Repeat the air pressure decrease procedure for the remaining three tires.
8. Training is complete after the horn sounds for the last tire trained (driver's side rear tire), the system indicator stops flashing, and the message center (if equipped) displays TRAINING COMPLETE.
9. Turn the ignition off. If two short horn beeps are heard, the reset procedure was unsuccessful and must be repeated.
10. Set all four tires to the recommended air pressure as indicated on the Safety Compliance Certification Label or Tire Label.
TIRE PRESSURE MONITOR SYSTEM REMINDER > TPMS REMINDER RESET -
PROCEDURE 7
Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.