MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2015–2017 source collection · Additional coverage

Diagnostic Strategy — Complete Repair

Automatic Transmission - 6-Speed Automatic Transmission - 6R80

Source configuration appliesSource reference 8,731HTML edition
← Chapter contentsManual collection

each suspect system.

DIAGNOSIS AND TESTING > DIAGNOSTIC STRATEGY > PINPOINT TESTS

The pinpoint tests are divided by component or system. Each test is a series of circuit checks to verify the integrity of the wiring harness between the PCM/ TCM and the solenoid or sensor.

DIAGNOSIS AND TESTING > DIAGNOSTIC STRATEGY > COMPONENT TESTS

The component tests are divided by system. Each test lists the possible symptoms the system can exhibit. For each symptom is a list of components that could cause the symptom. The components are listed in least intrusive to most intrusive order.

DIAGNOSIS AND TESTING > DIAGNOSTIC STRATEGY > PERFORM REPAIR

There are over 400 individual components in an automatic transmission. All of these parts must be in good working order. Many repairs are fairly straight forward. In these repairs you will:

Clean and inspect all parts removed

Attempt to determine root cause of the failure

Identify and repair/replace any related damaged parts

Carefully document findings on the repair order

In the case of clutch failure where the transmission fluid is heavily contaminated with friction material, the transmission needs to be overhauled. The repair will require complete disassembly and cleaning of the transmission. All seals and gaskets (except the reusable pan gasket) should be replaced.

DIAGNOSIS AND TESTING > DIAGNOSTIC STRATEGY > COMPLETE REPAIR

After reassembling the transmission, several steps are required to properly restore the vehicle before returning it to the customer.

Initial transmission fluid fill - this may be completed before the transmission is installed in the vehicle

Clear adaptive tables - required for overhaul and when the solenoid body has been replaced

Reset misfire monitor - required whenever the transmission has been removed

Road Test until the transmission fluid is up to operating temperature, this is required to make sure transmission fluid cooler is full of transmission fluid

Perform adaptive drive cycle - required if the adaptive tables were cleared

Set transmission fluid level - transmission fluid is now at the correct temperature and that the

Ford_Mustang_all_2015-2017.pdf · source reference 8731

Original technical text and illustrations, formatted as HTML. Follow the engine, transmission, equipment, model and year specified in the source. Import and layout checks do not establish applicability to every 2015–2017 Mustang. About this collection.