Are the resistances greater than 10,000 ohms?
Yes | GO to D18 |
|---|---|
No | REPAIR the circuit in question. GO to D21 |
D18 CHECK THE HORIZONTAL SENSOR CIRCUITS FOR AN OPEN
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C362-2 | C341B-8 | |
C362-4 | C341B-14 |
Are the resistances less than 3 ohms?
Yes | INSTALL a new horizontal motor. REFER to: Front Seat Track Motor (501-10A Front Seats, Removal and Installation). GO to D21 |
|---|---|
No | REPAIR the circuit in question. GO to D21 |
D19 CHECK THE DSM (DRIVER FRONT SEAT MODULE) OPERATION
Ignition OFF. Disconnect and inspect all of the DSM connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins as necessary pushed-out pins - install new pins as necessary
Reconnect the DSM connectors. Make sure they seat and latch correctly.
NOTE: Do not reconnect Driver Side Airbag In-line C345 at this time. Reconnect all previously disconnected connectors. Ignition ON. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DSM. REFER to: Driver Front Seat Module (DSM) (501-10A Front Seats, Removal and Installation). GO to D21 |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. GO to D21 |
D20 CHECK THE DDM (DRIVER DOOR MODULE) OPERATION
Ignition OFF. Disconnect and inspect all of the DDM connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins as necessary pushed-out pins - install new pins as necessary
Reconnect the DDM connectors. Make sure they seat and latch correctly. Connect: Driver Door Lock Control Switch C541. Ignition ON. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new DDM. REFER to: Driver Door Module (DDM) (419-10 Multifunction Electronic Modules, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
D21 VERIFY THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) PROVES OUT SUCCESSFULLY
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Connect: Driver Side Airbag In-line C345. Connect all previously disconnected connectors.
REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures).
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.