Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C352-8 | C363-3 | |
C352-10 | C363-1 |
Are the resistances less than 3 ohms?
Yes | INSTALL a new driver seat control switch. REFER to: Front Seat Control Switch (501-10A Front Seats, Removal and Installation). GO to F10 |
|---|---|
No | REPAIR the circuit in question. GO to F10 |
F10 VERIFY THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) PROVES OUT SUCCESSFULLY
REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Connect: Driver Side Airbag In-line C345. Connect all previously disconnected connectors.
REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures).
Did the SRS prove out successfully?
Yes | Repair is complete. RETURN the vehicle to the customer. |
|---|---|
No | REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). |
DTC: B1317
Refer to Wiring Diagrams Cell 123 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Front Seats - System Operation and Component Description (501-10A Front Seats, Description and Operation).
DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
B1317 Battery Voltage High | NOTE: DTC B1317 may be stored in the module memory due to previous battery charging or vehicle jump starting events. The DSM continuously monitors the input voltage for correct operation. If the DSM detects input voltage above 15 volts, it stores DTC B1317 in memory. If DTC B1317 is set, the DSM disables the memory system outputs for the driver seat memory operation. |
Possible Causes
Wiring, terminals or connectors DSM
PINPOINT TEST G : DTC: B1317
G1 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B1317, B1676 OR P0563 SET IN OTHER MODULES
Ignition ON. Using a diagnostic scan tool, retrieve the Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.
Is DTC B1317, B1676 or P0563 set in more than one module?
Yes | DIAGNOSE the charging system concern. Refer to the appropriate section in Group 414 for the procedure. |
|---|---|
No | GO to G2 |
G2 CHECK THE BATTERY VOLTAGE
Turn off all interior/exterior lights and accessories. Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage
Does the battery voltage rise to 15 volts or higher?
Yes | DIAGNOSE the charging system concern. Refer to the appropriate section in Group 414 for the procedure. |
|---|---|
No | GO to G3 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.