B8 CHECK FOR CORRECT WINDSHIELD WIPER MOTOR OPERATION
corrosion (install new connector or terminal - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the windshield wiper motor connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new windshield wiper motor. REFER to: Windshield Wiper Motor - LHD (501-16 Wipers and Washers, Removal and Installation). TEST the system for normal operation. If the concern is still present, GO to B9 |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
B9 CHECK FOR CORRECT SCCM (STEERING COLUMN CONTROL MODULE) OPERATION
Disconnect and inspect all the SCCM connectors. Repair:
corrosion (install new connector or terminal - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the SCCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
The High Speed Windshield Wipers Are Inoperative
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description (501-16 Wipers and Washers, Description and Operation).
Possible Causes
Windshield wiper motor Wiper/washer switch SCCM
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.