Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C218A-9 | C218A-10 |
Is the resistance greater than 10,000 ohms?
Yes | GO to A18 |
|---|---|
No | REPAIR the circuits. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A23 |
A7 CHECK THE DRIVER AIRBAG STAGE 2 CIRCUITS FOR AN OPEN
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Remove the driver airbag. REFER to: Driver Airbag (501-20B Supplemental Restraint System, Removal and Installation). Disconnect RCM C310A and C310B. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C310A-22 | C216B-1 | |
C310A-21 | C216B-2 |
Are the resistances less than 1 ohm?
Yes | GO to A9 |
|---|---|
No | GO to A8 |
A8 CHECK THE DRIVER AIRBAG STAGE 2 CIRCUITS FOR AN OPEN (CLOCKSPRING DISCONNECTED)
Disconnect Clockspring C218A. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C310A-22 | C218A-9 | |
C310A-21 | C218A-10 |
Are the resistances less than 0.5 ohm?
Original table alignment retained · Scroll horizontally if needed
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.