Is any voltage present?
Yes | REPAIR the circuits. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A16 |
|---|---|
No | GO to A7 |
A7 CHECK THE PASSENGER FRONT DOOR SIDE IMPACT SENSOR FEED CIRCUIT FOR A SHORT TO VOLTAGE (NO OPERATION INDICATED)
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect Passenger Front Door Side Impact Sensor C644. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C644-1 | Ground | |
C644-2 | Ground |
Is any voltage present?
Yes | REPAIR the affected circuits. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A16 |
|---|---|
No | GO to A14 |
A8 CHECK THE LH (LEFT-HAND) B-PILLAR SIDE IMPACT SENSOR AND RCM (RESTRAINTS CONTROL MODULE) CONNECTIONS (NO OPERATION INDICATED)
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Gain access to the LH B-pillar side impact sensor and inspect C3210 to make sure it is fully seated and locked. Seat and lock the connector as necessary. Gain access to the RCM and inspect C310A and C310B to make sure they are fully seated and locked. Seat and lock the connector(s) as necessary. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Was DTC B1415:93 retrieved on-demand during self-test?
Yes | GO to A9 |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.