Yes | INSTALL a new RH front impact severity sensor. REFER to: Front Impact Severity Sensor (501-20B Supplemental Restraint System, Removal and Installation). GO to A11 |
|---|---|
No | GO to A3 |
A3 CHECK THE RH (RIGHT-HAND) FRONT IMPACT SEVERITY SENSOR FEED CIRCUIT FOR A SHORT TO GROUND
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RCM C310A and C310B. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1466-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to A4 |
|---|---|
No | REPAIR the circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11 |
A4 CHECK FOR A SHORT BETWEEN RH (RIGHT-HAND) FRONT IMPACT SEVERITY SENSOR CIRCUITS
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1466-1 | C1466-2 |
Is the resistance greater than 10,000 ohms?
Yes | GO to A9 |
|---|---|
No | REPAIR the circuits. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A11 |
A5 CHECK THE RH (RIGHT-HAND) FRONT IMPACT SEVERITY SENSOR AND RCM (RESTRAINTS CONTROL MODULE) CONNECTIONS (NO OPERATION INDICATED)
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System,
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.