MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Body & Paint

Pinpoint Test - DTC: Z

501-20B Supplemental Restraint System

2016 MustangReference 2,001 / 6,619HTML edition
← Chapter contentsProcedure contents

General Procedures). Inspect the RH Front Impact Severity Sensor C1466 to make sure it is fully seated and locked. Seat and lock the connector as necessary. Gain access to the RCM and inspect C310A and C310B to make sure they are fully seated and locked. Seat and lock the connector as necessary. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.

Was DTC B1417:93 retrieved on-demand during self-test?

Yes

GO to A6

No

The fault has been corrected. GO to A11

A6 CHECK THE RH (RIGHT-HAND) FRONT IMPACT SEVERITY SENSOR FEED CIRCUIT FOR A SHORT TO VOLTAGE (NO OPERATION INDICATED)

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Disconnect RH Front Impact Severity Sensor C1466. Disconnect RCM C310A and C310B. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Measure:

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

C1466-1

Ground

Is any voltage present?

A7 CHECK THE RH (RIGHT-HAND) FRONT IMPACT SEVERITY SENSOR CIRCUITS FOR AN OPEN (NO OPERATION INDICATED)

Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Measure:

Click to display connectors

Positive Lead

Measurement / Action

Negative Lead

Source reference 2001

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.