NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, Diagnostic Trouble Codes (DTCs) may set.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
A1 RETRIEVE RCM (RESTRAINTS CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Were Diagnostic Trouble Codes (DTCs) C0061:68, C0062:68, C0063:68, C0064:68, or C0065:68 the only Diagnostic Trouble Codes (DTCs) retrieved?
Yes | CLEAR the RCM Diagnostic Trouble Codes (DTCs). GO to A2 |
|---|---|
No | DIAGNOSE all other RCM Diagnostic Trouble Codes (DTCs) first. REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). |
A2 CHECK FOR A RETURNING FAULT
Test drive the vehicle. Choose a route with LH and RH turns. Avoid rough roads and do not drive the vehicle aggressively. Using a diagnostic scan tool, perform RCM self-test.
Were Diagnostic Trouble Codes (DTCs) C0061:68, C0062:68, C0063:68, C0064:68, or C0065:68 the only RCM Diagnostic Trouble Codes (DTCs) retrieved?
Yes | GO to A3 |
|---|---|
No | If no RCM Diagnostic Trouble Codes (DTCs) were retrieved, the Diagnostic Trouble Codes (DTCs) may have been triggered by aggressive driving or rough road conditions. INFORM the customer that aggressive driving conditions or rough road conditions can set these Diagnostic Trouble Codes (DTCs). RETURN the vehicle to the customer. If any other RCM Diagnostic Trouble Codes (DTCs) were retrieved, DIAGNOSE those Diagnostic Trouble Codes (DTCs). REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). |
A3 CHECK THE RCM (RESTRAINTS CONTROL MODULE) INSTALLATION
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Inspect the RCM installation and make sure that the hardware is fully seated and tightened correctly. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). Inspect the RCM mounting surface for damage, corrosion, or foreign materials.
Is the RCM mounted correctly and is the mounting surface clean and free from damage?
Yes | GO to A4 |
|---|---|
No | REPAIR the mounting or INSTALL new hardware, as necessary. GO to A6 |
A4 CONFIRM THE RCM (RESTRAINTS CONTROL MODULE) FAULT
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.