18. Depower the SRS Refer to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures).
19. Remove the airbag. Refer to the appropriate procedure in this section.
20. If the airbag does not have a hard-wired pigtail, cut each of the airbag wires near the electrical connector that connects to the vehicle wire harness.
21. Remove any sheathing (if present) and strip the insulation from the ends of the cut wires.
22. NOTE: Typical driver airbag with 2 loops shown, other airbags with multiple loops or multiple features (canister vent, active tether) similar.
For airbags with multiple loops, twist together a wire from each loop then repeat for the remaining wires from each loop.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.