Corrosion Prevention

501-25 Body Repairs - General Information 2016 Mustang

General Procedures Procedure revision date: 07/2/2013

Special Tool(s) / General Equipment

Corrosion Prevention — original illustration 1, reference 2196Original colors & callouts · Select to enlarge	300-SAT12740 UBE Gun
Corrosion Prevention — original illustration 2, reference 2196Original colors & callouts · Select to enlarge	300-SAT9795 HRS Rust Gun

Materials

Name	Specification
Motorcraft® Metal Surface Prep ZC-31-A	-
ValuGard™ Premium Undercoating VG101, VG101A	-
ValuGard™ Rust Inhibitor VG104, VG104A	-

Repair

NOTE: Undercoating

NOTE: The following illustrations are not vehicle specific and are intended for reference only.

1. WARNING: Before beginning any service procedure in this section, REFER to Safety Warnings

in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Body Repair Health and Safety and General Precautions (100-00 General Information, Description and Operation).

2. Wire brush the area and make sure the surfaces are free of oil, dirt and other foreign material. Carry out the undercoating process in the following sequence.

3. Thoroughly clean and degrease metal surfaces to remove wax and grease. Material : Motorcraft® Metal Surface Prep / ZC-31-A

4. For best results, the vehicle should be at room temperature.

5. Canister attaches directly to the dispensing gun. Attach the undercoating canister to the special tool . Use Special Service Tool: 300-SAT12740 UBE Gun. Material : ValuGard™ Premium Undercoating / VG101, VG101A

6. Undercoating should be applied after the welding and refinishing process. Product cannot be welded through.

7. Air pressure setting for applicator gun is 552 kPa (80.06 psi) – 621 kPa (90.07 psi).

Source reference 2196

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.