Brake Pedal and Bracket - 6-Speed Automatic Transmission - 6R80
Base Part Number: 2455
Removal
NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE: Removal steps in this procedure may contain installation details.
1. NOTICE: Do not service the brake pedal or brake booster without first removing the stoplamp
switch. The switch must be removed with the brake pedal in the at-rest position. The switch plunger must be compressed for the switch to rotate in the bracket. Attempting to remove the switch when the plunger is extended (during pedal apply) will result in damage to the switch.
Remove the stoplamp switch. Refer to: Stoplamp Switch (417-01 Exterior Lighting, Removal and Installation).
2. Detach the 3 wiring harness retainers.
Source reference 2909
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.