Anti-Lock Brake System (ABS) and Stability Control — 2016 workshop reference 2950

Condition Possible Sources Actions Loose wheel speed sensor or INSPECT wheel speed sensor for looseness or excessive excessive air gap air gap. TIGHTEN or INSTALL new as necessary. REFER to: Front Wheel Speed Sensor (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). REFER to: Rear Wheel Speed Sensor (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). Parking brake out of adjustment (dragging) REFER to: Parking Brake (206-05 Parking Brake and Actuation, Diagnosis and Testing). The traction control Refer to the Pinpoint Test GO to Pinpoint Test E system cannot be disabled The Line Lock Vehicle is on an incline The vehicle must be on a flat surface for Line Lock feature cannot be Engine is not running feature use. MOVE vehicle to a flat surface and selected from the Selectable driving ATTEMPT to select the Line Lock feature. track application mode is set to START the engine and ATTEMPT to select the menu (grayed out) Snow-Wet Line Lock feature. Vehicle is traveling The Line Lock feature cannot be used with faster than 40-48 km/h Snow-Wet drive mode selected. SELECT Track (25-30 mph) drive mode and ATTEMPT to select the Line Lock Diagnostic Trouble feature. Codes (DTCs) present The vehicle cannot be moving when selecting the in the ABS module Line Lock feature. STOP the vehicle and ATTEMPT to select the Line Lock feature. Using a diagnostic scan tool, RETRIEVE all ABS module Diagnostic Trouble Codes (DTCs). GO to the DTC Chart: ABS Module The Line Lock Vehicle is on an incline The vehicle must be on a flat surface for Line Lock feature cannot be Engine is not running feature use. MOVE vehicle to a flat surface and initialized Selectable driving ATTEMPT to initialize the Line Lock feature. mode is set to START the engine and ATTEMPT to initialize the Snow-Wet Line Lock feature. Vehicle is traveling The Line Lock feature cannot be used with faster than 40-48 km/h Snow-Wet drive mode selected. SELECT Track (25-30 mph) drive mode and ATTEMPT to initialize the Line Diagnostic Trouble Lock feature. Codes (DTCs) present The vehicle cannot be moving when initializing the in the ABS module Line Lock feature. STOP the vehicle and ATTEMPT to initialize the Line Lock feature. Using a diagnostic scan tool, RETRIEVE all ABS module Diagnostic Trouble Codes (DTCs). GO to the DTC Chart: ABS Module The Line Lock Spare tire is installed REPAIR and INSTALL the road wheel and feature cannot be Driver or passenger ATTEMPT to engage the Line Lock feature. engaged door is open CLOSE the open door and ATTEMPT to engage

Original table alignment retained · Scroll horizontally if needed

Transmission is in the Line Lock feature. PARK or REVERSE The transmission must be in a forward gear for the Parking brake is Line Lock feature to engage. PLACE the applied transmission in DRIVE or FIRST GEAR and Steering wheel is not in ATTEMPT to engage the Line Lock feature. the straight-ahead RELEASE the parking brake and ATTEMPT to position engage the Line Lock feature Vehicle is on an incline TURN the steering wheel to the straight-ahead Engine is not running position and ATTEMPT to engage the Line Lock Driver applied brake feature. pressure is not high The vehicle must be on a flat surface for Line Lock

Source reference 2950

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.