Convertable Top Switch
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C9013-8 | C9013-2 |
Is the voltage greater than 11 volts?
Yes | INSTALL a new component. |
|---|---|
No | REPAIR the circuit in question. |
All Non-Networked Illumination Is Always On (Networked Illumination Functions Correctly)
Refer to Wiring Diagrams Cell 71 for schematic and connector information.
Normal Operation and Fault Conditions
The BCM provides PWM voltage to all non-networked illumination sources.
DTC | Description | Fault Trigger Conditions |
B1315:15 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery or Open | A continuous and on-demand DTC that sets in the BCM when the BCM detects a lower than expected current draw from the backlighting illumination output circuit. |
Possible Sources
Wiring, terminals or connectors
PINPOINT TEST D : ALL NON-NETWORKED ILLUMINATION SOURCES ARE ALWAYS ON
(NETWORKED ILLUMINATION FUNCTIONS CORRECTLY)
D1 RETRIEVE AND RECORD DIAGNOSTIC TROUBLE CODES (DTCS)
Using the diagnostic scan tool, retrieve all Diagnostic Trouble Codes (DTCs).
Is DTC B1315:15 present?
Yes | GO to Pinpoint Test B |
|---|---|
No | GO to D2 |
D2 CHECK THE BACKLIGHTING ILLUMINATION OUTPUT CIRCUITS FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect BCM C2280B. Ignition ON.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.