Do the non-networked components continue to illuminate?
Yes | REPAIR the circuit in question. | |
|---|---|---|
No | GO to D3 | |
D3 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Disconnect and inspect all BCM connectors. Repair:
corrosion (install new connector or terminals — clean module pins) damaged or bent pins — install new terminals/pins pushed-out pins — install new pins as necessary
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for thei concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSB address this concern, Click here to access Guided Routine (BCM).. | |
|---|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. | |
The Driver Door Lock/Memory Set Switch Illumination Is Inoperative Or Always On
Refer to Wiring Diagrams Cell 100 for schematic and connector information.
Normal Operation and Fault Conditions
The DDM supplies voltage to illuminate the driver door lock/unlock memory set switch.
DTC | Description | Fault Trigger Conditions |
U2010:00 Switch Illumination: No Sub Type Information | A continuous and on-demand DTC that sets in the BCM when the DDM detects a short to ground or open on the switch illumination circuit. |
Possible Sources
Wiring, terminals or connectors Driver door lock/unlock switch DDM
PINPOINT TEST E : THE DRIVER DOOR LOCK/MEMORY SET SWITCH ILLUMINATION IS
INOPERATIVE OR ALWAYS ON
E1 VERIFY THE DOOR LOCK SWITCH FUNCTINALITY
Actuate the door locks from the driver door lock switch.
Can the doors be locked and unlocked from the driver door lock switch?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.