Parking Aid

U0423:00

Invalid Data Received from Instrument Panel Cluster Control Module: No Sub Type Information

This DTC sets in continuous memory when the PAM receives invalid network data from the IPC with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no IPC Diagnostic Trouble Codes (DTCs) are present, DIAGNOSE the observable symptom.

U0429:00

Invalid Data Received From Steering Column Control Module: No Sub Type Information

This DTC sets in continuous memory when the PAM receives invalid network data from the SCCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no SCCM Diagnostic Trouble Codes (DTCs) are present, DIAGNOSE the observable symptom.

U0554:00

Invalid Data Received From Accessory Protocol Interface Module: No Sub Type Information

This DTC sets in continuous memory when the PAM receives invalid network data from the APIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no APIM Diagnostic Trouble Codes (DTCs) are present, DIAGNOSE the observable symptom.

U0557:00

Invalid Data Received From Front Controls Interface Module "A": No Sub Type Information

This DTC sets in continuous memory when the PAM receives invalid network data from the FCIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no FCIMDiagnostic Trouble Codes (DTCs) are present, DIAGNOSE the observable symptom.

U0558:00

Invalid Data Received From Front Controls/Display Interface Module: No Sub Type Information

This DTC sets in continuous memory when the PAM receives invalid network data from the FCDIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. If no FCDIM Diagnostic Trouble Codes (DTCs) are present, DIAGNOSE the observable symptom.

U2024:41

Control Module Cal-Config Data: General Checksum Failure

CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the PAM self-test. If DTC U2024:41 is retrieved again, INSTALL As-Built data from Professional Technician Society (PTS), following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration (418-01 Module Configuration) . REPEAT the self-test. If DTC U2024:41 is retrieved again,

Click here to access Guided Routine (BCM)..

U2100:00

Initial Configuration Not Complete: No Sub Type Information

CHECK the vehicle service history for recent service actions related to this module. This DTC can set due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, INSTALL As-Built data from Professional Technician Society (PTS), following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration (418-01 Module Configuration) .

If there have been no recent service actions, Click here to access Guided Routine (BCM)..

U2101:00

Control Module Configuration Incompatible: No Sub Type Information

CHECK the vehicle service history for recent service actions related to this module. This DTC can set due to incomplete or incorrect PMI procedures. If there have been recent service actions with this module, INSTALL As-Built data from Professional Technician Society (PTS), following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration (418-01 Module Configuration) .

If there have been no recent service actions, Click here to access Guided Routine (BCM)..