Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4011-2 | C4011-1 |
Click to display connectors
DTC B1B46:12
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4012-2 | C4012-1 |
Click to display connectors
DTC B1B48:12
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4009-2 | C4009-1 |
Click to display connectors
DTC B1B50:12
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4010-2 | C4010-1 |
Is the resistance greater than 10,000 ohms?
Yes | If all the sensor Diagnostic Trouble Codes (DTCs) are set, GO to D5 If one or more (but not all) parking aid sensor(s) recorded Diagnostic Trouble Codes (DTCs), INSTALL a new sensor(s) for the one in question. REFER to: Rear Parking Aid Sensor (413-13A Parking Aid - Vehicles With: Rear Parking Aid, Removal and Installation). |
|---|---|
No | REPAIR the circuit in question. |
D5 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all BCM connectors and related in - line connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the BCM connectors and related in - line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.