MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Instrumentation and Warning Systems

Parking Aid

413-13A Parking Aid - Vehicles With Rear Parking Aid

2016 MustangRear Parking AidReference 3,954 / 6,619HTML edition
← Chapter contentsProcedure contents

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical

Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM)..

No

The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.

DTC B1B44:96, B1B46:96, B1B48:96, B1B50:96

Refer to Wiring Diagrams Cell 131 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Parking Aid - System Operation and Component Description (413-13A Parking Aid - Vehicles With: Rear Parking Aid, Description and Operation).

DTC Fault Trigger Conditions

DTC

Description

Fault Trigger Conditions

B1B44:96 Right Rear Outer Sensor:

Component Internal Failure

A continuous and on-demand DTC that sets when the right rear outer parking aid sensor has internally failed or has an incorrect attenuation time.

B1B46:96 Right Rear Inner Sensor:

Component Internal Failure

A continuous and on-demand DTC that sets when the right rear inner parking aid sensor has internally failed or has an incorrect attenuation time.

B1B48:96 Left Rear Outer Sensor:

Component Internal Failure

A continuous and on-demand DTC that sets when the left rear outer parking aid sensor has internally failed or has an incorrect attenuation time.

B1B50:96 Left Rear Inner Sensor:

Component Internal Failure

A continuous and on-demand DTC that sets when the left rear inner parking aid sensor has internally failed or has an incorrect attenuation time.

Possible Sources

Wiring, terminals or connectors Parking aid sensor PAM (integral to the BCM)

NOTE: Before disconnecting the PAM or any of the parking aid sensors, verify the connectors are properly seated and latched.

PINPOINT TEST E : DTC (DIAGNOSTIC TROUBLE CODE) B1B44:96, B1B46:96, B1B48:96, B1B50:96

E1 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE PAM (PARKING ASSIST CONTROL MODULE) SELF-TEST

Using a diagnostic scan tool, perform the PAM self-test. Check the PAM Diagnostic Trouble Codes (DTCs) from the self-test.

Are parking aid Diagnostic Trouble Codes (DTCs) other than B1B44:96, B1B46:96, B1B48:96 or

Source reference 3954

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.